bbf c-head ideas
Page 2 of 2 • Share •
Page 2 of 2 • 
1, 2
Re: bbf c-head ideas
Curt on December 22nd 2011, 8:32 am
Mine made 1088 @ 7400/7500 rpm, with one single dyno QFX carb. Dyno'd on gas 
Jet Boat, Lem and Charlie build.
My cam
Some wacky adapter to fit my tunnel ram to one carb. Actually, the top of my intake is wacky and built for an Enderle and my T-2 set up.
At the time, this was the highest horsepower C headed, 598 engine on Mike's dyno built by the above. If may have been de-throned since then.
I'll post the sheet for the first time.
Jet Boat, Lem and Charlie build.
My cam
Some wacky adapter to fit my tunnel ram to one carb. Actually, the top of my intake is wacky and built for an Enderle and my T-2 set up.
At the time, this was the highest horsepower C headed, 598 engine on Mike's dyno built by the above. If may have been de-throned since then.
I'll post the sheet for the first time.
Curt- Posts: 1680
Join date: 2009-02-08
Age: 49
Location: Henrietta, Texas but mostly on the road 
C-460 combination
Gary Blair on December 22nd 2011, 9:53 am
Sometimes all you need to do is keep it simple. Keep the intake port small, just cartridge roll the runner, no increase in cross section. Focus on the bowl and valve job. Get after the cam, compression, and carb.
Gary Blair- Posts: 48
Join date: 2009-10-28 -
Page 2 of 2 • 1, 2
Page 2 of 2
Permissions in this forum:
You cannot reply to topics in this forum