Chuck's 1970 Mustang: The Rebuild...

Where's the pics ???

I don't have the car back yet.I hope too have it back this weekend.

Here are some pictures for you Dave.

I still need to put some bead rolls in the firewall panel and the panels over the 4-link, but other than that they are complete. The front tree was previously pop riveted in place, so I reused the plates and most of the same holes to install it. I have finished the front tree out of CM and it is still removable, so that Dan can take it out to paint it. I have to trim the edges of the firewall, so that I can finish the install of the support tubing for the back edge of the front fenders. I hope to finish that up this weekend.

Looks very nice Bill. I sure wish I lived closer to you. I'd have you finish my project without a doubt.

Looking nice Bill !

Thanks for posting the pictures Bill.Like I have been telling everyone the pictures just don't do it justice.You have to see it in person!!

You do great work!!!!

NICE engine block you have there

Do you guys rememer that 466 that split a cylinder? That's the block

Bill I agree, you do GREAT work

Very nice job!!

Looks like lots of leg room too!!

Bill

Hey guys got the car back today.I got new pictures I hope too have them up tomorrow.

Lonewolf1970 wrote:Hey guys got the car back today.I got new pictures I hope too have them up tomorrow.

Its tomorrow you big baby.... wheres the pics !!!!

Here's the pictures free loader.... click the thumb nail and then browse the album on photo bucket

[img][/img]

Dats gonna be a bad mo fo !!!!

Bill does AWESOME WORK!! I'm surprised there is enough room for Tiny to stay in FRONT of the rear axles?? I bet it'd be easier to set you up a 70's Lincoln or something of the like with 4 doors Chuck I can't wait to see it in person



Boo Boo

Car looks great Chuck. Awesome job Bill. Can't wait to see it finished. What's the paint scheme gonna be?







Doug...