CPR HEADERS

HAS ANYONE USED CPR HEADERS? IJUST JUST PURCHASED 2 1/4 A-460 HEADERS FOR MY FOXBODY
WITH BBC EXHAUST PORTS AND NUMBER 4 AND 8 CYL. TUBE PASS THROUGH IN BACK OF THE STRUT
TOWERS, GO DOWN AND BACK TOWARD THE BACK OF THE ENGINE COMPARTMENT WHERE IT JOINS
TO THE COLLECTOR. I HAVE NOT CUT OUT IN BACK OF THE STRUT TOWERS YET BUT WOULD LIKE ANY
IDEAS BEFORE HACKING AWAY.

Some of the A460 headers are like that. I know the D&D pieces are like that.

I believe cpr headers make accufab headers. The are a good product. There just isnt room to fit 2 1/4 head ers without doing it that way.

I'm pretty sure they make D&D's headers, nice pieces

Acufab provides a nice product and are, from my experiences, good people to work with. The header design you mention, tube passing behind the strut tower, reminds me of a set of Hooker race headers I installed on a 1970 Torino Cobra with a version of our famed Ford 385 Series engine, odd but made for an easier installation. You can only get so many big tubes through a given area!

Dave.

Mike R wrote:I'm pretty sure they make D&D's headers, nice pieces

sorry but that is incorrect information, but thanks for the compliment of our headers being nice!.
we have no affiliation with CPR headers!
we have been doing these swaps & providing headers and components since 1987 which predated most of the current suppliers of these type of components.

thanks

D&D AUTOMOTIVE SPECIALTIES
Ford and Mustang Performance
610-759-2492
ddautosp@ptd.net
www.ddautospec.com

They don't make them for Accufab either.....but they are made by the same folks.