i need help with head cam combo

Go down

i need help with head cam combo

Post  2POWERADDERS on July 27th 2015, 1:54 pm

im going to start gathering pieces for my 460 and i need some advice... i have a standard bore 460, d00e rods and a 2yabc crank, d3ve pistons, i am currently looking for a set of d0ve heads and what cam shaft???? ok if im totally on the wrond road with this combo let me know... i have a wide ratio toploader with 4.10 gears and a 30 inch tall tire and weigh in at 2600-2700 lbs when im done.... its going in a 51 henry j strait axle gasser... i have 2 1/4 inch headers with a 3 1/2 collector and a open muffler and a dual plane intake... thats about all the info i have...please help me not screw this up!!!!
avatar
2POWERADDERS

Posts : 51
Join date : 2012-11-25

View user profile

Back to top Go down

Re: i need help with head cam combo

Post  2POWERADDERS on July 27th 2015, 2:29 pm



avatar
2POWERADDERS

Posts : 51
Join date : 2012-11-25

View user profile

Back to top Go down

Re: i need help with head cam combo

Post  rmcomprandy on July 27th 2015, 5:36 pm

Is this to be a race car or a "nostalgia" type cruise vehicle...?

Headers are to big for either.

rmcomprandy

Posts : 5149
Join date : 2008-12-02
Location : Roseville, Michigan

View user profile http://www.rmcompetition.com

Back to top Go down

Re: i need help with head cam combo

Post  2POWERADDERS on July 27th 2015, 6:07 pm

Just something for the street, I had those laying around that's why I put them on
avatar
2POWERADDERS

Posts : 51
Join date : 2012-11-25

View user profile

Back to top Go down

Re: i need help with head cam combo

Post  rmcomprandy on July 27th 2015, 10:47 pm

2POWERADDERS wrote:Just something for the street, I had those laying around that's why I put them on

Those D3 pistons and D0 heads work well together. Get a "street rod" type camshaft; similar to a THUMPER.
But, I would get something ground with a smaller exhaust lobe when using that 2 plane intake; around 226/234@.050", under .535" lift or so with a tight separation.

rmcomprandy

Posts : 5149
Join date : 2008-12-02
Location : Roseville, Michigan

View user profile http://www.rmcompetition.com

Back to top Go down

Re: i need help with head cam combo

Post  gmsmkr on July 29th 2015, 5:09 pm

I have a comp thumper cam in a block in the shop. miles unknown but it's yours just pay the shipping to where you are if you want it...... all lobes look good
avatar
gmsmkr

Posts : 1364
Join date : 2014-06-22
Location : alabama

View user profile

Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum