BIG BLOCK FORD
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Cam

4 posters

Go down

Cam Empty Cam

Post  fordmonsta February 19th 2017, 6:15 pm

Looking to upgrade my 552 I'm taking the dish pistons out and putting flat tops in it while it's apart I'm going to have some cleanup work done on the heads they are aluminum scj heads should flow close to 400 when they're done compression is 13.5 is there an off the shelf cam that yall like or just go custom car will be a bracket rig

fordmonsta

Posts : 222
Join date : 2012-12-30

Back to top Go down

Cam Empty Re: Cam

Post  BBFTorino February 20th 2017, 1:36 am

Solid roller for sure!

BBFTorino

Posts : 982
Join date : 2015-12-31

Back to top Go down

Cam Empty Re: Cam

Post  Straubtech February 20th 2017, 6:24 pm

If they are getting ported then I would get the flowed. Knowing the engine combination and flow numbers will give you the info need to get the correct camshaft.

Straubtech

Posts : 293
Join date : 2015-03-31

Back to top Go down

Cam Empty Re: Cam

Post  Lem Evans February 20th 2017, 8:35 pm

fordmonsta wrote:Looking to upgrade my 552 I'm taking the dish pistons out and putting flat tops in it while it's apart I'm going to have some cleanup work done on the heads they are aluminum scj heads should flow close to 400 when they're done compression is 13.5 is there an off the shelf cam that yall like or just go custom car will be a bracket rig

For a big Ford aluminum SCJ head I'd doubt that there is any thing "off the shelf" that would be real good. Most of those cams were done before those heads were even born.

Lem Evans

Posts : 7445
Join date : 2008-12-03
Location : Livermore , Ky

http://bfevansraceparts.com

Back to top Go down

Cam Empty Re: Cam

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum