E7TA-7505 aluminum bellhousing /truck

Go down

E7TA-7505 aluminum bellhousing /truck Empty E7TA-7505 aluminum bellhousing /truck

Post  JBR-3 on September 22nd 2019, 8:00 pm

This bellhousing has mounting for a hydraulic slave cylinder.
Trans mounting bolt pattern appears to be symmetrical 8.5" horizontal separation and 6.25" vertical separation.

Which transmission was used here ?

***********

It appears to be the same pattern as the Ford TKO-500/600, although I don't know yet
if the input shaft flange ID is the same.


Last edited by JBR-3 on September 22nd 2019, 8:45 pm; edited 2 times in total (Reason for editing : more ino)

JBR-3

Posts : 244
Join date : 2009-08-17

Back to top Go down

E7TA-7505 aluminum bellhousing /truck Empty Re: E7TA-7505 aluminum bellhousing /truck

Post  68coupestang460 on September 25th 2019, 5:25 pm

I have one of these bells as well from a 1986 F350 truck. Just bought it for a 1978 460cid that i'm mounting a big block toploader to.

Toploader mounts perfect. Also the trans that was on the truck this bell came from was a T19.

So this pattern is a pretty standard Ford pattern.

~gary

68coupestang460

Posts : 1
Join date : 2018-10-25

Back to top Go down

E7TA-7505 aluminum bellhousing /truck Empty Re: E7TA-7505 aluminum bellhousing /truck

Post  BBFTorino on September 26th 2019, 2:26 am

Some of the F250/350's came with a ZF 5 speed manual transmission. This is likely what the bell is for.

BBFTorino

Posts : 800
Join date : 2015-12-31

Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum