lapping valves after a valve job
+7
rmcomprandy
DaveMcLain
the Coug
nuclearcobra
c.evans
69F100
514Fox87
11 posters
Page 1 of 1
Re: lapping valves after a valve job
Thanks for the tips learn something new today
69F100- BBF CONTRIBUTOR
- Posts : 5381
Join date : 2009-01-04
Age : 57
Location : Irwinville Ga.
Re: lapping valves after a valve job
I lap and bounce test all my valves when I do a valve job. I just like having the piece of mind that they are right. Even on them old flathead continentals!!
kens68stang- Posts : 35
Join date : 2009-08-12
Age : 60
Location : mcclure pa
Re: lapping valves after a valve job
BTW guys, the lap and bounce works good on women also.
Dave
Dave
DJOHAGIN- Posts : 91
Join date : 2009-09-16
Location : Santa Clara, CA
Re: lapping valves after a valve job
Liar you just got me slapped
nuclearcobra- BBF CONTRIBUTOR
- Posts : 1385
Join date : 2009-08-16
Location : Delaware Coast
Re: lapping valves after a valve job
nuclearcobra wrote:Liar you just got me slapped
You didn't lap her correctly!
The Pope- Posts : 126
Join date : 2009-09-10
Age : 59
Location : Garner ( Raleigh N.C.)
Re: lapping valves after a valve job
I know but i got some brownie points for trying i think
nuclearcobra- BBF CONTRIBUTOR
- Posts : 1385
Join date : 2009-08-16
Location : Delaware Coast
Similar topics
» the dove c heads i bought , i measured the intake valves they were 2.250 assuming these are not stock valves ?
» How do you check valve to valve clearance????
» Titanium valves: 2.25 valves SOLD; 2.35 valves SOLD,2.40 valves SOLD
» valve cover studs for aluminum valve covers
» Going from Ferrea 2.20 valve to 2.25, Is there a better flowing valve for ported STREETS?
» How do you check valve to valve clearance????
» Titanium valves: 2.25 valves SOLD; 2.35 valves SOLD,2.40 valves SOLD
» valve cover studs for aluminum valve covers
» Going from Ferrea 2.20 valve to 2.25, Is there a better flowing valve for ported STREETS?
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|