wtb.4x4 c4 output shaft & tailshaft

Looking for a c4 output shaft and tailshaft from a 4x4 application.

Thanks, Casey.

did they evr make a 4x4 c-4? i've been told it never existed

good luck you are asking for something that isn't made.... most 4x4 were c-6's



Randy

Weren't C-4's used in the early 66-77 Bronco's?

could have been Schmitty but I have seen a few and were fmx if I remember right.... but still like looking for live dinasaurs at that if they were in those ....


Randy

You just need the output shaft and the housing that goes in between the trans and transfer case?
Almost all the early broncos ('66-'77) that were automatics had C-4s in them, I've seen a few c-5s, but I thought they were replacements. My particular set up is a PA C4 with brake, and a PA convertor.

yeah like was stated, early bronc's had C-4's

I was thinking of using the shorter output shaft with a gv o/d unit to try and lessen the overall length of the trans.

I have something of that nature but it has a very short tailshaft with a fixed yoke. 1st and only one I have ever seen.

Guys, thanks for the input. I've gone another direction with my trans so I won't be needing the short output.

waypastcrazy wrote:I have something of that nature but it has a very short tailshaft with a fixed yoke. 1st and only one I have ever seen.

That is probably for a van. I have one like that out of a '68 Econoline van.