"Custom" A460 Intake

I had five of these intakes machined from scratch. I sold four of them and kept this one. It is partially assembled, but still needs finished. Since it's a custom deal, you may find you like the route I was going with it or you may decide to change it up a bit. The options are endless. It's setup to work with an A460 TR top (single or dual).

A picture is worth a thousand words...Here is how the intake looks right now:

The black soot is from preheating the intake runners to weld them. I would put a coat of soot (oxy/ace) and, when the soot burned off, I figured I had enough heat in the part to get good penetration.








All my extra intake flanges are included.


You'll need to cut the valley pan (front/back) off and re-weld. I recommend welding the rest of the runners onto the flanges before re-welding the valley pan (because of warpage).

This can be made to work with a carb or EFI setup. This may not be a 100% optimized setup, but it has good potential and, for those who care, it will look good sitting atop a BBF .

More photos:

http://s53.photobucket.com/albums/g69/96Mustang460cid/96%20Mustang/New%20Engine%20-%20March%2031%202008/DIY%20Intake%20Manifold/

http://s53.photobucket.com/albums/g69/96Mustang460cid/96%20Mustang/New%20Engine%20-%20March%2031%202008/DIY%20Intake%20Manifold/Intake%20Assembly/

$350 + shipping/insurance

No low-ballers, please.

Have a good day!
Michael

TTT

Have a good day!
Michael

I had a guy who supposedly sent me a money order for some of this stuff. The money order hasn't arrived and the person isn't responding to PMs. Honesty can be hard to come by...I guess.

TTT


Have a good day!
Michael

TTT

Have a good day!
Michael