Nitrous feed lines
3 posters
Page 1 of 1
Nitrous feed lines
geno January 19th 2014, 10:40 am
I have a plate system and a fogger. The plate has a -4 feed line and the fogger has a -6. I am only going to use the plate on the trans brake with a 150 shot. I plan to add another 150 shot somewhere in the run. My question is, could I change the inlet to the fogger to a -4 and still supply enough nitrous. What determines the size of the feed line?
geno- Posts : 103
Join date : 2013-01-24
Location : Mobile, Alabama
Re: Nitrous feed lines
richter69 January 19th 2014, 11:53 am
both my foggers with have -4s, Ive seen a pair of -4s on a fogger support 500 plus hp . Now the main line from the bottle was a -6 and t'ed to the noids with -4s
richter69- Posts : 13649
Join date : 2008-12-02
Age : 53
Location : In the winners circle
Re: Nitrous feed lines
whatbumper January 19th 2014, 3:13 pm
-04 won't hold you back much if any at the power levels you seek.
whatbumper- Posts : 3024
Join date : 2009-11-11
Age : 43
Re: Nitrous feed lines
geno January 19th 2014, 8:04 pm
Thank you whatbumper and richter69. I need to just inbox you guys with my stupid questions. Thanks again!!!
geno- Posts : 103
Join date : 2013-01-24
Location : Mobile, Alabama
Re: Nitrous feed lines
richter69 January 19th 2014, 10:28 pm
No need for that..... Also w a -4 the shorter the better.
richter69- Posts : 13649
Join date : 2008-12-02
Age : 53
Location : In the winners circle
Similar topics» For Sale/NITROUS NOS PROGRAMMABLE NITROUS CONTROLLER #15834
» Hydraulic lines
» Transmssion lines ?
» Tranny lines
» Fuel lines
» Hydraulic lines
» Transmssion lines ?
» Tranny lines
» Fuel lines
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum|
|
|