460 headers

429/460 headers for factory style heads

2-1/4" OD stainless chassis headers...no collectors...$250.00 + shipping***SOLD

Sanderson block hugger shorties, used for mock-up only, never run...no collectors...$150.00 + shipping***SOLD

used Fox body tri-Y headers...collectors, shortie pipes, mufflers, & turndowns all welded together...$125.00 +
shipping--Sold






If anyone is interested in the Fox Body headers, I'll have to get better pictures of them.

Where did you get that engine stand and what was the $

what is the size of the fox headers?

res0rli9 wrote:Where did you get that engine stand and what was the $

The label says ADT. I bought it several years ago for just under $200. It is the typical Asian junk...the casters are carp. After I replaced the casters and shimmed the gearbox, it is great. A strong stand that folds up for storage. Its great to turn the crank for just the right angle and no danger of a heavy BB getting away from you. The only down side is that the head is not removable for bolting to the block. The traditional stand allows you to remove the head and bolt it to the block then you can just slide the head and block into the stand. Another feature is the height...it is taller than most and much taller than the cheap ones. I am tall and it killed my back hunching over those short ones. All in all...great stand. It is my primary. Everytime that I have more than one project going, I consider buying another one. Even thought the price is twice that of a typical stand, I would buy another. If I remember correctly, Matco offers one as well as Summit and/or Jegs.

Disclaimer--stand is in the picture but is NOT included in the sale nor is it being offered for sale.

michealj wrote:what is the size of the fox headers?

The primary tubes are 2"OD, the secondaries are 2-1/4" and the collectors, exhaust pipe, mufflers, and turn downs are 3". I forgot to measure the H pipe. Used but still in good condition.

PM sent to you Gary.

pm sent

res0rli9 wrote:Where did you get that engine stand and what was the $

check this one out http://www.northerntool.com/shop/tools/product_200349940_200349940 they have several others as well

PM sent

97BigBlock wrote:pm sent

Fox header sale pending..........thanks

GaryS wrote:

97BigBlock wrote:pm sent

Fox header sale pending..........thanks

Fox Body headers SOLD and shipped..........thanks

Recieved quickly and as described. Thanks again Gary!

PM sent

Any interest in the Sandersons or the chassis headers??????????

What were the chassis headers built for?