My new Racecars

I picked it up about a month ago as a roller. It's a 03 Mullis and Backhalved and undated in 06 by Undercover. And the wiring was a mess. We straighten out the wiring and put my motor and trans in it. Here are the pictures the day i picked it up.

Here is what the motor looked like in my dads car.


I cleaned it up and repainted it to go in the Dragster

Good to see you going again

Good Job !

Here are the picture once we got it in the garage.







I took the oil pan off the shim the oil pump so we can get 80psi of oil pressure. It was at 65psi when it was in my dads car.


First test fit


Trans is painted


Motor plate painted

Looks great guys glad y'all are back in it

Your going to love that K&R air compressor on that dragster... I wish i had one on ours.


Nice cars
What happen to the door car?

Ace

powerstrokeace wrote:Your going to love that K&R air compressor on that dragster... I wish i had one on ours.


Nice cars
What happen to the door car?

Ace

It got caught in a trailer fire

https://www.429-460.com/t14402-the-worst-night-of-my-life-i-can-t-believe-it

Looking good..
How long is that trans from bell face to end of tall housing, Thanking about getting one for my junk.
Just wont to see how much I can set the motor back.

Looking good. Are those the headers from the door car too?

I sure do miss the dragster we had. I still have the cockpit so maybe one day we'll resurrect it...

jbozzelle wrote:Looking good. Are those the headers from the door car too?

I sure do miss the dragster we had. I still have the cockpit so maybe one day we'll resurrect it...

No they came with the Dragster. They are Dynatech headers for a BBC that came with the Dragster. But they would fit a doorcar. The headers that were on my dads car look good on the Dragster also. But these have merge collectors so that's why we are using them.

Looking good, glad to see your keeping at it.

I'm glad to see you guys got to salvage a few things . I hope you have great luck with it!!

Man, that looks like one of the Lawn Darts from here in southern Ohio, nice job, and good luck.

yall moved fast .....now we just need some video of the beast running

res0rli9 wrote:Looking good..
How long is that trans from bell face to end of tall housing, Thanking about getting one for my junk.
Just wont to see how much I can set the motor back.

I don't know I will have to measure it. It's a stock PG case turned into a shorty PG for a Dragster

Only thing I'd worry about is if the shorty cover can support the yoke on a driveshaft? It's done on some suspended dragsters but those shafts are real short too. I'd worry about the whipping effect of a long driveshaft wearing out the support bushing/bearing in the shorty cover.

https://www.youtube.com/watch?v=SPuSMLKAJFk

https://www.youtube.com/watch?v=TEHduMjzrIc