Strange 9" center section..........complete

I aquired this thing on a trade, I cant use nor do I need it.
Its a strange nodular case, 3.250 carrier bearings
Richmond 3.20 pro gear, 35 spline big pinion
The pinion support is a triple bearing, male 20 spline yoke
40 spline lightweight steel spool
Has the load bolt on the side for ring gear deflection
I pulled this thing apart and all the bearings, races etc look great
Gears have little wear, pattern looks good

I need to recoup my money so its gonna go for 695.00 and I'll pay shipping to the lower 48
I'll asume it was set up for a dragster by the pinion support, yoke, and the tall gear.
It will accept a std 35 spline pinion progear, it will not take a std pinion support as the case has been
bored a tad to accept the oversize support.

Reply, pm, text or call 405 574 two three one seven

buy with confidnce guys !!!!! sweet deal Jon

I too can say Jon is a good guy to deal with fellas. Bump

its gonna be a tough sell due to the limited nature of the yoke and pinion support.

Definately a piperack piece. Great deal for someone.

a good machinist could make a ring to go around a reg support to locate it into the housing and use a reg yoke........ which I may have done if i dont sell it and have a spare lol.

Have seen this in person. Very nice quality and top notch work. GLWS