Cometic Intake Gaskets

What is the price and part# for a set cometic intake gaskets to fit P-51 and Mafia intake?

$29.97 C5206-060

Lem Evans wrote:$29.97  C5206-060

Thanks i got some TA31 from local Ford Dealership today.So let me get this right i smear TA31 on both side of gasket and use it on front/rear block.

Are the Cometic gaskets better than the Felpro units?

jasonf wrote:Are the Cometic gaskets better than the Felpro units?

IMO yes

From what I can gather from searching the gasket posted above would be correct for TFS power port heads? How about the exhaust gasket for tfs head?

I don't use exhaust gaskets, I use ultra copper silicone.

I used the Ford 441 gasket for years at over 15:1 compression, not saying it's better, just saying. Lem has them worth the money.

jasonf wrote:From what I can gather from searching the gasket posted above would be correct for TFS power port heads?  How about the exhaust gasket for tfs head?

that part # intake gasket is the CJ size. It can be used on the std. size ports if the mainifold has enough flange area.

The cometics aint got any "give", just make sure its all good n flat. Id use copper cote on the intake ports and a small bit of ta31 on the water ports..... On a mafia p51 they will need a little massage for proper fit.... A sand roll in a dremel tool is the best way to trim um.

dfree383 wrote:I don't use exhaust gaskets, I use ultra copper silicone.

Yeah but how long do they have to last on the dyno??         Sorry I couldn't resist.

if the flange is flat and thick they will outlast the rest of the engine........ well for some anyways.

jasonf wrote:

dfree383 wrote:I don't use exhaust gaskets, I use ultra copper silicone.

Yeah but how long do they have to last on the dyno??         Sorry I couldn't resist.

Zing!   

dfree383 wrote:I don't use exhaust gaskets, I use ultra copper silicone.

x2. Gaskets are a pain, the Permatex Ultra Copper just plain works.