K member spacers -> ride height?
3 posters
Page 1 of 1
K member spacers -> ride height?
BigBlockRanger April 2nd 2010, 12:22 pm
With the 1.5" spacers do you guys have to cut your springs to maintain the correct ride height?
BigBlockRanger- Posts : 1204
Join date : 2008-12-02
Age : 53
Location : Amarillo
Re: K member spacers -> ride height?
billandlori April 2nd 2010, 1:15 pm
I used the stock 5.0 T-Bird srpings and cut one full coil (half was broke already!!). This got me a good stock ride height. With the Hooker headers I wouldn't want to go any lower.
It sure gets the engine sitting a bunch better, I use a mechanical fan and stock shroud.
Bill
It sure gets the engine sitting a bunch better, I use a mechanical fan and stock shroud.
Bill
billandlori- Posts : 2081
Join date : 2009-08-06
Age : 54
Location : Stratford, Ontario, Canada
BigBlockRanger- Posts : 1204
Join date : 2008-12-02
Age : 53
Location : Amarillo
Re: K member spacers -> ride height?
frank13 April 2nd 2010, 9:10 pm
th eone issue i got when i put the spacers in was the steering shaft was now too short .....may take em out now
frank13- Posts : 532
Join date : 2009-01-05
Age : 50
Location : Phila Pa -
Re: K member spacers -> ride height?
billandlori April 2nd 2010, 10:57 pm
frank13 wrote:th eone issue i got when i put the spacers in was the steering shaft was now too short .....may take em out now
The steering shaft is telescoping, you can just pull it out a bit further. I had to push mine in and extend the lower steering shaft to clear my &^$%(&%^#** Hooker headers.
Bill
billandlori- Posts : 2081
Join date : 2009-08-06
Age : 54
Location : Stratford, Ontario, Canada
Re: K member spacers -> ride height?
billandlori April 2nd 2010, 10:58 pm
BigBlockRanger wrote:Thanks Bill!
Anytime!!
Bill
billandlori- Posts : 2081
Join date : 2009-08-06
Age : 54
Location : Stratford, Ontario, Canada
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum|
|
|