Looking for a short short C6 tail housing (found one)

Ford used them on the 70's Econoline vans with a 351/C6 combo.
I'm looking for one for my truck so I can use a 4x4 shorty tail shaft setup.

mike

f250mike wrote:Ford used them on the 70's Econoline vans with a 351/C6 combo.
I'm looking for one for my truck so I can use a 4x4 shorty tail shaft setup.

mike

Good luck, I looked for 2yrs and only found one at a trans shop and he wouldn't sell it
was saving it for an in and out job...find 2 and I'll take one also

I have one from a 83 e250 w/351/c6. But,I looked at it today and the shaft on it is not a short one. Sorry

Keith if I find a couple I'll let you know.

Thanks for looking Rick.

mike

f250mike wrote:Ford used them on the 70's Econoline vans with a 351/C6 combo.
I'm looking for one for my truck so I can use a 4x4 shorty tail shaft setup.

mike

Mike I have a C6 with the bolt on Yoke short shaft out of a FE Trans. Built to handle my 1000 h.p. 535 cid. Have $3500.00 in it with the 10" 3500 Stall converter. I'll take some pictures of it .
Yes it's still dirty but it still has all the safety shield on it.
It also has 3 SFI flex plates for it.

Here you see it's only 30"long

Dan

Dan the tail housing I'm looking for is a little different from yours. One like yours may work though.
Here's a pic of what I'm looking for.

mike I may have found one ,the guy has a spare that I told him I'd buy
Frank

Frank I sent you a PM.

mike

I gess Ford dont sell the tail shaft and housing anymore for the van one????

I got lucky and found one right away on ebay and was the only bidder.
Thanks for the help guys.
mike