BIG BLOCK FORD
Would you like to react to this message? Create an account in a few clicks or log in to continue.
BIG BLOCK FORD

BIG BLOCK FORD TECHNICAL AND PARTS SITE

OAKLEY MOTORSPORTS ENGINES, CUSTOM CARBS, COMPLETE ENGINE MACHINING, PORTING SERVICE AND DYNO SERVICE. CALL 270-344-0912, 270-929-5185


Crower part info?

2 posters

BIG BLOCK FORD :: GENERAL TECH :: ENGINE TECH

Go down

Crower part info? Empty Crower part info?

Post  fordpwr2000 September 13th 2009, 10:18 pm

Just picked up a motor complete, it has not been run in 6 years and tore it down today and its a d1 block and i got the pan off and it has the 4 bolt kit on 2,3, and 4! Just starting here next I see the crower rods and they carry a Z stamped on them and they are a 6.8 next the crank is a crower also and it is stamped T78 3950 (i think this is the stroke from some quick measurements) and CA 24564 and then scribed on the counterwieght is 66CS. Can anyone give me a heads up on this crank? I did email crower but form past experiance i know they will get back to me IF THEY FEEL LIKE IT! Thanks Greg

fordpwr2000

Posts : 19
Join date : 2009-09-09

Back to top Go down

Crower part info? Empty Re: Crower part info?

Post  DJOHAGIN September 17th 2009, 9:02 pm

Then it might be good to call them also.

The squeaky wheel gets the grease. Wink

Dave

DJOHAGIN

Posts : 91
Join date : 2009-09-16
Location : Santa Clara, CA

Back to top Go down

Back to top

BIG BLOCK FORD :: GENERAL TECH :: ENGINE TECH

 
Permissions in this forum:
You cannot reply to topics in this forum