Boss Hemi,SOLD !

Ford Boss Hemi 605 c.i.
Sonny leonard sheetmetal intake manifold
AR valve covers
Jesel rockers
Smith Bros. 7/16 tapered push rods
Ron's Dual terminators fuel injection
C and C Motorsports Hemi Heads
2.5 titanium Intakes,1.9 titanium exhaust valves
60 mm,8/2 swap cam,C&C Motorsports custom grind
Jesel cam belt drive,
Jesel belt drive distributor
Arias 15/1, lateral gas port pistons,HD wrist pins
Carrillo rods,SPS Carr rod bolts
Sonny Bryant crankshaft
Engine Systems dry sump aluminum pan
Ford A96 Aluminum block
4.5 stroke,4.625 bore
C & C Motorsports Head studs
heads o-ringed,reciever groove in block,Clark copper head gaskets
MSD Super 8 plug wires
tilton starter
sfi balancer
electric water pump
low runs since new build.1400 hp on mild tune
Single stage Pro race fogger
This engine would cost over $35,000 to build
Asking $27,000
phone 319-234-0547 ,319-233-4145,cell 319-855-8200

BBBBBBBBBBBBBBeautiful piece!! Good luck on selling it!!

That would look cool in the bird Dano.

bbf-falcon wrote:That would look cool in the bird Dano.

That would look cool anywhere Rick!

Thanks for the good comments.I've had the car since 1987,This is the best engine I've had in it.
Along with pulling the lenco levers it makes the car one bad ass ride.
Pat

Damn that's cool.

Man that is straight bad ass!...i need hit the lottery so i can put this in Dads 60' Lloyd Alexander (smaller than a vw bug).



only his is tubed a 9" in the back and flip front w mustang II.

Good luck w the sale! i see you went with nothing but the best for parts. i can verify your build price after just finishing one.

Don

I have a set of original boss heads. Looking for complete hardware. Original stuff will work. Thanks Ted gasserted@yahoo.com

DAMN thats just bad azz!!! there is just no other way to put it!!!!!

Sale pending on engine,Rolling chassis and tranny[Bruno's with a three speed Lenco] still for sale.
Pat

Engine sold,Rolling chassis still for sale,handles alot of power,drives good.Tranny still for sale.