Hat injector manifold mounting plate
2 posters
Page 1 of 1
Hat injector manifold mounting plate
Hi everyone.
Finally got the carb flanges cut off my Weiand tunnel ram.
Whats the lightest aluminum I should go with to make the adapter plate. Bear in mind there is only 4 3/8s bolts that hold the hat. The 13 1/4inch is a long spread IMO. This baby is gonna pull down pretty good.
I have some .125 and 3/8ths. Whatcha think?
Thanks.
Finally got the carb flanges cut off my Weiand tunnel ram.
Whats the lightest aluminum I should go with to make the adapter plate. Bear in mind there is only 4 3/8s bolts that hold the hat. The 13 1/4inch is a long spread IMO. This baby is gonna pull down pretty good.
I have some .125 and 3/8ths. Whatcha think?
Thanks.
72mav- Posts : 1081
Join date : 2008-12-03
Age : 61
Location : central Michigan
Re: Hat injector manifold mounting plate
3/8" at least IMO.
cool40- BBF CONTRIBUTOR
- Posts : 7308
Join date : 2009-08-31
Age : 53
Location : on the 1/8 mile dyno
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum