Crank triggers. 4 or 12 magnets?
4 posters
Page 1 of 1
Crank triggers. 4 or 12 magnets?
I am going to switch over to a crank trigger and find 4 and 12 magnet wheels. What I can't find is which one I should use. Can anyone offer some advice? Application is a 533 alky motor, bracket racing.
Thanks
Alan
Thanks
Alan
Re: Crank triggers. 4 or 12 magnets?
HorsinAround wrote:I am going to switch over to a crank trigger and find 4 and 12 magnet wheels. What I can't find is which one I should use. Can anyone offer some advice? Application is a 533 alky motor, bracket racing.
Thanks
Alan
4 magnets for a V-8, replacing a distributor triggered ignition.
HorsinAround likes this post
Re: Crank triggers. 4 or 12 magnets?
I think more is better to a point. I would do a 12 magnet (I did) but I have Holley efi.
jasonf- BBF CONTRIBUTOR
- Posts : 2994
Join date : 2009-07-14
Age : 55
Location : Lafayette, LA
Re: Crank triggers. 4 or 12 magnets?
More isn’t better…… you need what you need for the signal, no more no less.
dfree383- BBF CONTRIBUTOR
- Posts : 14852
Join date : 2009-07-09
Location : Home Wif Da Wife.....
Similar topics
» differences in 68-69 crank pulley to 70 and up crank pulley for Lincoln with crank PS
» piston to deck height
» aluminum crank pulley and a crank trigger
» running a crank trigger setup from msd , i need a distributer now , i see the crank trigger one but says only for sheet metal intakes ???
» Crank advice needed
» piston to deck height
» aluminum crank pulley and a crank trigger
» running a crank trigger setup from msd , i need a distributer now , i see the crank trigger one but says only for sheet metal intakes ???
» Crank advice needed
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum