Break in oil??
5 posters
Page 1 of 1
Break in oil??
jason July 27th 2012, 12:44 pm
Just did a freshin up total seal rings and new bearings, same cam and lifters . What are you guys using?
jason- Posts : 220
Join date : 2009-08-14
Age : 52
Location : superior wi
Re: Break in oil??
jc10000rpm July 27th 2012, 11:38 pm
if using same cam and lifters i see no reason to do anything special, most modern rings seal in little time and with most any oil combo
jc10000rpm- Posts : 193
Join date : 2008-12-03
Re: Break in oil??
richter69 July 27th 2012, 11:49 pm
vr1 to seat the rings, then in the green stuff goes.......... 
richter69- Posts : 13649
Join date : 2008-12-02
Age : 53
Location : In the winners circle
Re: Break in oil??
cool40 July 28th 2012, 1:23 am
that green stuff is hard to beat....richter69 wrote:vr1 to seat the rings, then in the green stuff goes..........
cool40- BBF CONTRIBUTOR
- Posts : 7308
Join date : 2009-08-31
Age : 53
Location : on the 1/8 mile dyno
Re: Break in oil??
Barney July 28th 2012, 1:29 am
X3cool40 wrote:that green stuff is hard to beat....richter69 wrote:vr1 to seat the rings, then in the green stuff goes..........
Barney- Posts : 2577
Join date : 2009-12-02
Age : 48
Location : Kirkland, Il -
jason- Posts : 220
Join date : 2009-08-14
Age : 52
Location : superior wi
Similar topics» Uh oh.....break-in gone bad??
» Cam Break In
» Engine break in oil
» break in oil?
» Used cam break in.
» Cam Break In
» Engine break in oil
» break in oil?
» Used cam break in.
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum|
|
|