Jim's Little 460 AND 2000 RANGER

I hope you git r done soon! She's looking sweet, didn't you say you were going to get taller wheels for the back? Bigger diameter one's should fill the wheel well better and give it an awesome look.

Yes I will be putting 31x10.5x15 on it when I finish with the build these are some stock car tires my brother gave me for mock up.Might do a big burn out with them before I pull them off for the fun of it.

69F100 wrote:Yes I will be putting 31x10.5x15 on it when I finish with the build these are some stock car tires my brother gave me for mock up.Might do a big burn out with them before I pull them off for the fun of it.

Video tape that!

Just a couple update pics got one panel put in the bed I got the others cut out and carrying them to work tomorrow to bend in the brake should finish the bed this weekend.

Well got the sides and the front done tonight I will put the floor of it in tomorrow and the bed will be finished then it will be time to make the firewall that will be the hardest as I don't want to pull the engine back out but they may not be any way around not pulling it except taking the windshield out.It is going to come out later when I buy the lexan but don't want to take it out until then.





Not the best pics they are from my cheap call phone

Looking Real Good

Here is a pic in the day light my cell don't take to good at night I put the cables on the tailgate and couldn't hold on to the tailgate for it be so hot

Should finish to bed tomorrow got to pick up some alum trim from work to do alittle trim work and cut out for battery try and fuel cell.With the bed setup this way it gives me 16" clearance at the closest point in the wheel wale.The bed might way 100# no more than 125#

Cool cool cool! I love drag trucks! I'm going to have the heaviest drag truck on here when its done Haven't done anything to lighten it.

Got the bed finished all but seam sealing with aluminum caulk but that will be after I/we finish the inside.Now time to start the hard part the firewall after the firewall the rest want be that hard.

looken good Jim bo

Oooooohhh aaaaaaahhh! What do you think she will run in the 1/4 mile? Or 1/8 if that's all you'll race.

I am hoping it runs some where in the 6s

looks good ,i went to Douglas friday nite you got some stiff competition chebby guys runnin some low 6.20's couple 5.90's

I might not have the fastest truck around but I will have just as much fun as the others if not more.I haven't built it to be the fastest yet got to get some seat time in it 1st then maybe up the engine a bit and get in the low 6s or high 5s.What ever it runs will be ok for now.

just raggen you man its all about the fun cause we are not going to get rich doing it , there was a r-x7 there tune was off would not go down the track .

I know you were just ragging on me you did anything to yours lately or you just letting it collect dust oh ya close your hood before it blows up

got the dash finished except cutting hole for the gauges it is the same as color as the cage.got the tunnel sit in place but think about redoing it didn't turn out just as I wanted it to.the dash still has the plastic on it

no dust check out the new pic i took some more tried to load them in gallery but it wont let me upload them ,gutted doors,dash its all polished sheet metal now try to get pics up

Finished the inside except door panels today

Here is a few from the under side




Here are 2 from under the rear the 2nd is inside of the rear skin this what you see behind the tires on the rear

Looks real good.

is it Me or the pics. is that gas peddle gona bend ?

Good eyes and yes the gas paddle will bend I hadn't finished it wanted to make sure it would miss the tunnel work right before finishing it