Edelbrock Victor Jr plate kit???

I have an Edlebrock Victor Jr plate kit that I havent used in 4 years. Im getting my car back together now and Im going to be using this bad boy again and was wondering what if anything I need to do to it before using it again.

I would send it to Steve and have him flow that baby it makes alot diff. not going on hear say i been there and done that u will be very impressed to say the least.

What does he do when he flows it? Or what is trying to be determined by flowing it?

BLACKFOX wrote:What does he do when he flows it? Or what is trying to be determined by flowing it?

i sent him both my plate and fogger ........ read page #2 ...i will bump the thread for you too

http://www.429-460.com/t2625p15-intake-off-to-induction-solutions

Thanx Bruno for the info. Its interesting all the little issues you can have with a purchased kit.

With the Victor Jr. kits there are a few things that we find wrong with them. One is some of the earlier plates have leakage issues and another issue is line sizing. Not to mention if we blueprint and flow the system we can make the nitrous solenoids larger to improve flow as well as make a dramatic change to jetting to correct the nitrous to fuel ratio's. Hope this helps.. SJ