BIG BLOCK FORD
Would you like to react to this message? Create an account in a few clicks or log in to continue.
BIG BLOCK FORD

BIG BLOCK FORD TECHNICAL AND PARTS SITE

OAKLEY MOTORSPORTS ENGINES, CUSTOM CARBS, COMPLETE ENGINE MACHINING, PORTING SERVICE AND DYNO SERVICE. CALL 270-344-0912, 270-929-5185


Intake question

3 posters

BIG BLOCK FORD :: GENERAL TECH :: ENGINE TECH

Go down

Intake question Empty Intake question

Post  curiousgeorge April 10th 2010, 9:54 pm

Has anyone ever put an A-head intake on a set of conventional heads? I thought I seen where it's been done the other way and was just curious?

curiousgeorge

Posts : 167
Join date : 2008-12-03
Age : 41

Back to top Go down

Intake question Empty Re: Intake question

Post  bbf-falcon April 10th 2010, 10:04 pm

Look at the difference in the runner size of the two intakes. Quite abit of difference. Smile

bbf-falcon

Posts : 8995
Join date : 2008-12-03
Location : Jackson, Ohio

Back to top Go down

Intake question Empty Re: Intake question

Post  rmcomprandy April 11th 2010, 1:18 pm

Not so much the size of the ports but, the shape and their location; the "A" port is about an inch higher than a standard head intake port.

rmcomprandy

Posts : 6108
Join date : 2008-12-02
Location : Roseville, Michigan

http://www.rmcompetition.com

Back to top Go down

Intake question Empty Re: Intake question

Post  curiousgeorge April 11th 2010, 8:18 pm

I kinda figured that it wouldn't work, but I knew if it had been tried someone here would know.
Thanks guys.

curiousgeorge

Posts : 167
Join date : 2008-12-03
Age : 41

Back to top Go down

Intake question Empty Re: Intake question

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

BIG BLOCK FORD :: GENERAL TECH :: ENGINE TECH

 
Permissions in this forum:
You cannot reply to topics in this forum